Cocopeat for greenhouse tomato
Greenhouse tomato growers use buffered or low EC cocopeat in slabs of about 100 cm length, planted through pre-cut holes and fed by drip. A medium with pH 5.5 to 6.5 and EC below 0.5 mS/cm lets the grower set the nutrient recipe from the first irrigation.
- tomato cocopeat
- greenhouse tomato substrate
- coco slab for tomato
Format that suits tomato
High-wire tomato is usually grown on coco slabs or grow bags that hold roughly 12 to 25 litres per metre, set on gutters or the floor and watered by drip. Pure pith slabs retain more water, while pith and chip blends drain faster. Many Mediterranean and Indian polyhouse growers choose a 70:30 pith to chip fill for better root aeration.
EC and pH in the root zone
Growers commonly feed to an inflow EC of about 2.5 to 3.5 mS/cm, adjusting by stage and light, and keep the pH near 5.5 to 6.0. Start with a buffered medium or pre-treat low EC blocks so that calcium and magnesium are not stripped from the first feed. Drain EC should be monitored and run-off managed, typically 20 to 30 percent.
What to ask a supplier
Request EC and pH on a stated method, the fibre and chip share, slab dimensions, hole spacing and drain pattern. Ask for a sample slab before committing to a container, and test it with your own water.
Reuse and sanitation
Slabs are usually used for one long crop and sometimes a second. Reuse depends on disease history and your sanitation protocol, and it is wise to send used slabs for laboratory analysis before replanting.
| Parameter | Typical range |
|---|---|
| Slab length | About 100 cm |
| Volume per slab | About 12 to 25 L |
| Medium pH | 5.5 to 6.5 |
| Feed pH | 5.5 to 6.0 |
| Feed EC | About 2.5 to 3.5 mS/cm |
| Drain run-off | About 20 to 30% |
Key takeaways
- High-wire tomato is usually grown on coco slabs or grow bags that hold roughly 12 to 25 litres per metre, set on gutters or the floor and watered by drip.
- Growers commonly feed to an inflow EC of about 2.5 to 3.5 mS/cm, adjusting by stage and light, and keep the pH near 5.5 to 6.0.
- Request EC and pH on a stated method, the fibre and chip share, slab dimensions, hole spacing and drain pattern.
- Slabs are usually used for one long crop and sometimes a second.
Trial a sample slab or bag with your own water supply before you buy a container.
Need a specification or a quote? Send your requirement or message us on WhatsApp.
Questions and answers
Can cocopeat be reused for tomato?
Sometimes, for a second crop, if the crop was healthy and the slab is steam- or chemically sanitised. A laboratory analysis of the used slab guides the decision.
What is the best EC for tomato in cocopeat?
Feed EC of about 2.5 to 3.5 mS/cm is a common range, with a root-zone EC monitored through drain readings. Set your own targets with an agronomist.
How many tomato plants per slab?
Often two to three plants per 100 cm slab, depending on cultivar and system.
Related pages
- Coco SlabsPre-filled coco production slabs with planting holes and drainage cuts for greenhouse crops.
- Buffered CocopeatWashed and calcium-treated cocopeat that is ready to use with fewer Cal-Mag corrections.
- Cocopeat for greenhouse cucumberCucumber is a heavy water user, so growers choose a coir slab with good water-holding capacity and enough air space, usually a...
- Cocopeat for capsicum and bell pepperBell pepper grows well in buffered coir slabs or large bags, as it likes a steady moisture level and good drainage. A fill of...
Sources and further reading
Ready to source from India?
Tell us the product, quantity and destination port. We reply with a specification sheet and a quotation.