Cocopeat buyer's guide: grades, EC, formats and how to order
Cocopeat is a growing medium made from coconut husk pith. When you import it, four choices decide whether it suits your use: the EC grade (low, buffered or high), the format (block, briquette, grow bag or loose), the particle mix (fine pith or pith with husk chips) and the packing.
1. Choose the EC grade
| Grade | EC | Processing | Best for |
|---|---|---|---|
| Low EC (washed) | Below 0.5 mS/cm | Washed with fresh water | Greenhouses, nurseries, seedlings, potting mixes |
| Buffered | Below 0.5 mS/cm | Washed, then treated with calcium nitrate | Hydroponic vegetables, berries and flowers |
| High EC (unwashed) | Above 1.0 mS/cm | Dried and sieved only | Soil conditioning, landscaping, animal bedding |
2. Choose the format
5 kg blocks give the lowest freight cost per litre and suit professional growers and blenders. 650 g briquettes are the retail format. Grow bags and slabs are ready-made hydroponic rows. Open-top bags suit berries. Loose bags are pre-moistened and ready to use. Husk chips add air and drainage.
3. Decide the particle mix
Fine pith holds water; husk chips and short fibre hold air. Crops that like a moist root zone, such as cucumber and leafy greens, do well in a pith-rich mix. Crops that prefer drying between irrigations, such as tomato, roses and orchids, benefit from a higher share of chips.
4. Check these figures on the test report
- EC and the method used to measure it (1:1.5 by volume is common)
- pH, normally 5.5 to 6.5
- Moisture, normally below 18 to 20% for compressed products
- Expansion volume per kilogram
- Fibre and impurity content
5. How to hydrate a 5 kg block
Place the block in a large tub, add 20 to 25 litres of clean water and leave it for 20 to 30 minutes. Break it apart by hand and fluff it. One block yields about 70 to 75 litres. Use the Cocopeat hydration volume calculator.
6. Container quantities
A 40 ft high-cube container typically carries 22 to 26 tonnes of 5 kg blocks. Palletised loads carry less weight but unload faster. Try the Cocopeat container load calculator and read Cocopeat container loading.
Cocopeat and peat moss compared
| Property | Cocopeat | Peat moss |
|---|---|---|
| Source | By-product of coconut processing, renewable | Harvested from peat bogs, slow to regenerate |
| pH | 5.5 to 6.5 | 3.5 to 4.5, usually limed |
| Re-wetting | Re-wets easily when dry | Can become water-repellent when dry |
| Structure | Stable over one to two crop cycles | Breaks down and compacts sooner |
See the full Cocopeat vs peat moss page.
Cocopeat questions and answers
What is cocopeat made of?
Cocopeat is made from the pith of coconut husk, the fine spongy dust that remains after coir fibre is extracted. It is washed, dried, sieved and compressed for export.
What EC should cocopeat have for hydroponics?
For hydroponics and seedlings, choose washed cocopeat with an EC below 0.5 mS/cm, and ask for buffered material if your crop is sensitive to sodium and potassium.
How do you hydrate a cocopeat block?
Place the 5 kg block in a large tub, add 20 to 25 litres of clean water, wait 20 to 30 minutes and break it apart by hand. It expands to about 70 to 75 litres.
Is cocopeat the same as coir pith and coco coir?
Yes. Cocopeat, coir pith, coco peat and coco coir all refer to the same growing medium made from coconut husk pith.
How many 5 kg cocopeat blocks fit in a 40 ft container?
A 40 ft high-cube container typically carries 22 to 26 tonnes of 5 kg blocks, roughly 4,400 to 5,200 blocks, depending on whether the load is palletised.
A short decision path
Choose the crop and use. Choose the EC grade for the crop. Choose the format for your handling and freight. Choose the particle mix for water and air. Then check the report. This short path avoids most buying mistakes, and it keeps the conversation with a supplier specific.
Matching grade to use
Seedlings and hydroponic crops need low EC, often below about 0.5 mS/cm by the 1:1.5 volume method. Long, sensitive crops such as tomato and berries often use buffered coir. Soil conditioning, mulching and bedding can use higher EC. Always confirm the method.
Matching format to handling
Blocks suit volume buyers with a place to hydrate. Briquettes suit retail and small growers. Grow bags and slabs suit greenhouse growers who want ready-to-plant units. Chips and chip blocks suit open mixes and orchids.
Matching mix to water and air
Pith holds water. Chips add air. A mix with more chips drains faster. Ask for the ratio of pith to chips for any bag or slab, and trial it with your irrigation.
Budgeting and logistics
Plan the cost per usable litre, the freight to your port and the storage at your site. A 40 ft high-cube container typically carries about 22 to 26 tonnes of compressed blocks. Use our calculator for a planning figure, and confirm on the quotation.
Common questions after the first order
Buyers often ask how to reuse slabs, how to adjust feed to coir, how to store blocks and how to compare suppliers. Our learn pages answer these in detail.
Quick spoken answers
Short answers written to be read aloud by a voice assistant or a smart speaker.
How do I choose cocopeat?
Choose the EC grade for your crop, the format for your handling, and the particle mix for water and air, then check the batch report.
People also ask
Which cocopeat is best for tomatoes?
Many growers use buffered or washed low EC coir in slabs or bags. Ask your agronomist.
Which format is cheapest per litre?
Compressed 5 kg blocks, usually. Compare delivered cost per usable litre.
People also search for
- cocopeat buyer's guide
- how to choose cocopeat
- cocopeat grades
- low EC cocopeat guide
Explore more on Greenmark Exports
- Fresh Pomegranates
- Open-Top Coco Bags
- Cocopeat export to the Netherlands
- What is EC in cocopeat?
- HS codes for cocopeat, mango and pulp
- 5 kg block vs 650 g briquette
- Cocopeat for greenhouse tomato
- Tuticorin (V.O. Chidambaranar Port)
- Request a quote
- All products
- Frequently asked questions
- Site map
- Privacy policy
- Terms of use
About this page
Who wrote and checked it
Written by the Greenmark Exports export desk in Mumbai. Greenmark Exports is a partnership firm established 20 December 2025, with partners Fahad Jamal, Vikrant Kale. The firm holds GST registration (27ABDFG9926H1Z2), an Importer-Exporter Code (ABDFG9926H) and Udyam registration (UDYAM-MH-18-0511530).
How we prepared it
We build every page from public standards and agency guidance, which we list under Sources, and from the trade documents we work with ourselves. Where a figure is typical, not guaranteed, the page says so. We have not run grow trials ourselves and do not present first-hand crop results.
Last reviewed
2026-11-18. Found something out of date? Email exports@greenmarkexports.in and we will check it and correct the page.
Sources used
Related pages
- What is cocopeat?Cocopeat, also called coco peat, coir pith or coco coir, is the fine, spongy material left after the long fibre is removed...
- What is EC in cocopeat?EC, or electrical conductivity, measures the soluble salt in a cocopeat sample in millisiemens per centimetre. A low EC under...
- How to import cocopeat from IndiaTo import cocopeat from India, define the grade and packing, request a sample and test report, agree price and Incoterm, pay...
- hub-learnAnswers, comparisons, importer guides and calculators on cocopeat, EC, pH, buffering, container loading, export documents,...
Ready to source from India?
Tell us the product, quantity and destination port. We reply with a specification sheet and a quotation.